Latest Products
![PCB, Printed Circuit Board, Donut Board, Matrix Board, Fiber FR4, Tinned, Double Sided [180105881]](https://www.destiny-electronic.com/image/destinyelectronic/image/cache/defaultlazyload-420x420.jpg)
- Fiber, FR4 material grade
- Tinned copper
- Suitable for prototyping
RM20.80
RM45.00
- Infrared Reflector, TCRT5000L
- Operating Voltage: 3 to 5Vdc
- Analog Output (Voltage)
- Detection Distance: 15mm
- Pins Definition (3P Connector): Vcc, Out, GND
- Easy to use and Cost Effective
RM19.95
RM25.00
- Infrared Receiver, ZX-IRM
- Operating Voltage: 5Vdc
- Frequency: 38khz
- Digital Output
- Pins Definition (3P Connector): Vcc, Out, GND
- Returns a logic “1” when no signal is detected.
- Returns a logic “0” when a light signal is detected.
- Active with logic '0' or data changable at 1,200 times per second.
- Easy to use and Cost Effective
RM10.95
RM15.00
- Infrared Emitter
- Operating Voltage: 5Vdc
- Frequency: 38khz
- Digital Output
- Drive with logic High at TTL Level
- Pins Definition (3P Connector): Vcc, Out, GND
- Transmission Range: 5 to 10m
- 2-mode Operation: Continuous Drive or Frequency Drive
- Continuous Drive: In this mode, the IR-LED will receive a forward bias to drive the infrared rays. Use with the Inex Photo-transistor board for measuring the infrared light density.
- Frequency Drive: This mode will modulate a 38kHz carrier frequency into the IR-LED. (Can be used with the Inex 38kHz Infrared Receiver Module which is not included).
- Easy to use and Cost Effective
RM19.95
RM25.00
- Infrared Emitter
- Operating Voltage: 5Vdc
- Frequency: 38khz
- Digital Output
- Drive with logic High at TTL Level
- Pins Definition (3P Connector): Vcc, Out, GND
- Transmission Range: 5 to 10m
- 2-mode Operation: Continuous Drive or Frequency Drive
- Continuous Drive: In this mode, the IR-LED will receive a forward bias to drive the infrared rays. Use with the Inex Photo-transistor board for measuring the infrared light density.
- Frequency Drive: This mode will modulate a 38kHz carrier frequency into the IR-LED. (Can be used with the Inex 38kHz Infrared Receiver Module which is not included).
- Easy to use and Cost Effective
RM6.95
RM15.00
- Automatic voltage stabilizer
- Delay time function
- Low / high voltage protection
- Circuit breaker protection
- Input / output voltage display
- 1 outlet & 1x wire Input
- Handheld case
RM390.00
RM610.00
- Distance Measuring Range: 20 to 150cm / 10 to 80cm / 4 to 30cm
- Analog Output
- Operating Voltage: 4.5 to 5.5V
- Consumption Current: 33mA
- 3 Pins
- Dimensions: 29.5 x 13 x21.6 mm
RM24.95
RM40.00
- Frequency: 38kHz
- Wavelength: 940nm
- Operating Voltage: 5V
- 4 Emission Direction
- Digital Output
- Transmission Distance: up to 3m
- Pins Definition (3 Pins): GND, Vcc, DAT
- Dimensions: 35 x 35mm
RM12.95
RM30.00
- Suitable for 5 - 400Vac/Vdc inductive loads (Less than 1000w load)
- Built-In RC Snubber Circuit
- Varistor to Prevent Large Excessive Current / Voltage Fluctuation
- Protection on Electromagnetic Interference,, Anti-Interference
- 2P Terminal Connection
- Easy to use and Cost Effective
RM7.95
RM30.00
- Operating Voltage: 3.3V / 5Vdc
- Mechanical Angle: 270 Degrees
- Resistance: 10k ohm
- Analog Output (0 to Vcc)
- Pins Definition (3 Pins): OUT, Vcc, GND
- Easy to use and Cost Effective
RM10.95
RM30.00
- Operating Voltage: 3.3V / 5Vdc
- Mechanical Angle: 270 Degrees
- Resistance: 10k ohm
- Analog Output (0 to Vcc)
- Pins Definition (5 Pins): OUT, Vcc, GND
- Easy to use and Cost Effective
RM10.95
RM30.00
- Operating Voltage: 3.3V / 5Vdc
- Mechanical Angle: 360 Degrees
- Output: Pulse Level
- Positions per Revolution: 20
- Pins Definition (9 Pins): OTS, Vcc, GND, OTB, Vcc, GND, OTA, Vcc, GND
- Easy to use and Cost Effective
RM16.95
RM30.00
- Operating Voltage: 5Vdc
- Mechanical Angle: 360 Degrees
- Output: 2-bit gray code (Digital)
- Positions per Revolution: 30
- Pins Definition (5 Pins): GND, +5V, SW, DT, CLK
- Easy to use and Cost Effective
RM5.95
RM30.00
- Coded Disc, 20 holes
- Diameter: 25.8mm
- Hole Diamter: 1.2mm
- Applications: Motor Speed (RPM), Workpiece Couting
- Easy to use and Cost Effective
RM1.50
RM30.00
- Infrared Detection Technology (Vertical)
- Operating Voltage: 5Vdc
- Digital Output
- Infrared Detection Area: 10mm
- Pins Definition: Vcc, GND, OUT
- Detection Frequency: > 100kHz
- High Performance Stability
- Anti-Jamming Capability
- Applications: Motor Speed (RPM), Workpiece Couting
- Easy to use and Cost Effective
RM14.95
RM30.00